GO/ON 1324679 Manuel Utilisateur page 51

GETTING STARTED
WARNING: Always ensure that the plug is disconnected from power
source, the tool is switched off before making any adjustments or
maintenance procedures. Install the appropriate filter before placing the
motor assembly back on the tank. For more information on installing
your foam sleeve, refer to Operation. Remove the vacuum cleaner
and all of the accessories from the packaging. Open the locking
clamps with your thumbs and remove the motor assembly from the
tank. Then, remove the accessories from the tank. With the electric
cord disconnected from the outlet, and the motor assembly removed
from the tank, place the tank upside down so that the base is facing
upwards. Assemble the feet and the castors according to the following
instructions for your model.
CASTOR SYSTEM ASSEMBLY
Remove all of the straps holding the castor feet together.
1. Facing the tank's vacuum port, take castor feet marked A.
2. Insert the castor foot stem into the sockets also marked A, located on
the front left and rear right of the tank.
3. Make sure that the castor feet are fully inserted into the tank base
and attach using the screws supplied.
4. Take the castor feet marked B.
5. Insert the castor foot stem into the sockets also marked B, located on
the front right and rear left of the tank.
6. Make sure that the castor feet are fully inserted into the tank base
and tighten using the screws supplied. Turn the tank right side up
and replace motor assembly.
A
Attach the hose to the vacuum port located on the tank.
7
All manuals and user guides at all-guides.com
A A
A
A
A A
B
A
B
B
B
A
B