Publicité
Les langues disponibles
Les langues disponibles
UV Diffusers Installation and Operation Manual
j.
Put the UVC Barrier back in place and secure it by fully tightening the 4 screws holding it.
4. Secure the filter in place with the 3 filter clips. Make sure each clip is completely pushed on top of the filter
(Figure 7). The single clip is harder to push, you must press on the filter to force it. Make sure it is fully pushed
against the filter in order to ensure an airtight installation and optimal performance.
5. Put the diffuser face back in place, gently push the face up until both magnetic latches are locked.
Figure 6. Remove the four screws holding the UVC Barrier in place, then slowly pull down the UVC Barrier
Figure 7. Secure the filter back in place with the three filter clips. Make sure they are all fully pushed in
6. Dispose of the used filter and mercury lamp in a safe and responsible way, respecting local government
regulations.
p. 6
Publicité
