Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Intended Use
• This device is used for evporating water. It is exclusively meant for this purpose and must only be used for
this purpose. It may only be used in the manner as described in this manual.
• This product is not designed for use by persons (including children) who have reduced physical, sensory or
mental capacities or persons with no experience or knowledge, unless they are instructed and supervised in
the use of the appliance by a person responsible for their safety.
Transport
• Please keep the original packaging. To an adequate protection during transport of the device, pack the unit
in its original packaging.
Cleaning
Do not use volatile liquids, such as insecticide spray. Dont clean the surface with strong pressure otherwhise it
could get damaged. Rubber or plastic should not be in in contact with the devive over a longer period. Clean
the appliance and the floor using a soft cloth and warm water, if necessary, a soap solution. Never submerge
the base in water or any other liquid.
Assembly and Operating Instructions
1. For initial use, be sure the input voltage marked on the transformer must be same as your local power sup-
ply. If not, please don't use it until get a correct transformer from your local distributor.
2. Place the water guard which has been installed electronic unit in the center of glass bowl, Pull power cord
through the hole of glass bowl. Stuff up rubber tuck. (Don't pull power cord in the bowl to avoid rubber tuck
removing.)
3. Place the glass bowl on the wood stand.
4. Place the small glass cover on the stand of water guard.
5. Fill the bowl with water up to about 1/3 from the low edge of the bowl. It is better to let the water surface
1cm~2cm over upon the mist maker.
6. Plug the mist maker & lamp into the transformer.
7. Place the transformer in a dry place away from mist.
8. Plug the transformer into power source and unit will start working immediately.
6
Publicité
