dirna Bergstrom SCANIA NTG SLIM Instructions De Montage page 14

SLIM
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
Warning
!
If the unit slants during assembly, wait for at least
60 minutes with the unit in horizontal position before
starting it up.
Warning
!
In vehicles in which the electrical connection is
made to additional batteries which are independent
from the vehicle's start-up, the configuration of the
electronics to the new battery cut parameters is
optional (see page 22).
Warning
!
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Slim on roof, take into account that, normally,
cabins equipped with a hatch have a strong enough
structure to hold equipment weight. However, if it is not
the case and it is necessary to carry out a cut in the roof
or, although it has a hatch, the material is not resistant
enough (if roof is made of fibre, plastic, etc...), it is the
installer who will have to decide, under his responsibility,
if it is necessary to reinforce the roof to avoid possible
deformations, breaks, water entries, etc., habilitating the
means required to stop it from occurring.
Torx wrenches set
Allen wrenches set
Related documentation
Mounting instructions
User's guide
Troubleshooting
Parts list
Documentation included
Quick guide
Warranty
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
dirna Bergstrom, s. l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Equipment pre-charged with refrigerating gas.
(Do not handle refrigerating gas circuit).
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
!
The unit does not comply with ADR regulations.
14
Tools
1003173065
1003173067
1003173068
1003173066
1003243638
220AA10017
Symbology
Warnings
!