BoomToneDJ PAR 56 RGB LED Mode D'emploi page 12

3CH mode:
Channel
1
2
3
DMX 512 Connection
The DMX 512 is widely used in intelligent lightings and with a maximum of 512
channels.
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a
120 ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin
XLR-plug and plug it in the DMX-output of the last unit.
3. Connect the unit together in a 'daisy chain' by XLR plug from the output of
the unit to the input of the next unit. The cable cannot be branched or split
to a 'Y' cable. DMX512 is a very high-speed signal. Inadequate or damaged
cables solder joints or corroded connectors can easily distort the signal and
shut down the system.
4. Each lighting unit needs to have an address set to receive the data sent by
the controller. The address number is between 0-511 (usually 0 & 1 are equal
to 1).
Value
0-255 Red dimmer
0~255 Blue dimmer
0-255 Green dimmer
Function
11