Kenwood HM-L700 Manuel D'instructions page 32

Clock adjustment
As the clock is not only used to show the time of the day but also used in timer operations, be sure to set
the clock in advance.
1
Activate the clock adjustment mode.
1
Press the mode key.
2
Use the 4 and ¢ keys to select "TIME
ADJUST" and press the enter/demo key.
Main unit
\
\
Remote control unit
2
Set the day of the week, hour and minutes.
1
Use the 4 and ¢ keys to select the day
of the week and press the enter/demo key.
Main unit
Previous
Remote control unit
Main unit
2
In the same way, set the hour and minutes.
32 EN
\
\
Next
Remote control unit
÷ The day of the week starts flashing.
Example: When set to 8:07 Monday morning
÷ After setting and entering the day of the week, the
hours indication starts flashing. After setting and en-
tering the hours, the minutes indication starts flashing.
÷ The hours are displayed on the 12-hour (am/pm) clock.
Twelve o'clock noon is displayed as "12:00pm",
whereas twelve o'clock midnight is displayed as
"12:00am".
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
enter/demo key, the display shows "COMPLETE".
÷ The built-in clock keeps time for about 3 minutes after
the AC adaptor has been unplugged.
÷ If power is lost or the power cord is unplugged and
plugged back in, reset the time.
÷ When the STOP key is pressed while the power is in
the standby mode, the time of the day will be dis-
played for 8 seconds.
Timer operation