emerio SI-123338 Mode D'emploi page 7

Corded mode and storage position: Place the iron on the power stand. Press the lock button from the right to
the left position (see lock/unlock printing below). Rotate the iron until it is locked to the power stand.
Power lamp / auto-shut off lamp
This appliance is equipped with a power lamp / auto-shut off lamp on the handle.
When the iron is placed on the power stand, the power lamp is on. When lifted, the power lamp is off.
-
When the iron is in corded mode and placed horizontally for approx. 30 seconds or vertically for approx. 8
-
minutes without any operations, an internal safety feature will switch the iron off and the auto-shut off
lamp will blink. Beep sounds will be heard. Operate the appliance to switch it on again.
Note: In cordless mode the iron can be used for about 25 seconds. After this recharge the iron by placing it
for about 10-15 seconds on the power stand (13).
DRY IRONING

Connect the appliance to a suitable mains supply outlet.

Ensure that the steam setting is in the position "

Select the setting on the temperature regulator.

When the indicator light goes off, the required temperature is reached. The iron is ready for use.

To turn off the iron, turn the temperature regulator counter-clockwise to position "MIN", set the iron
upright, and pull out the power plug.
STEAM IRONING
Fill the water tank, as described before initial usage.
Steam ironing can be used in the temperature ranges ●, ●●, ●●●, MAX. For the reliable functioning of the
steam ironing, the water tank must be at least 1/4 filled.
Spraying function: Press the spray button to moisten a spot to be ironed. Water will come out of the spray
nozzle.
Steam function:
1) Turn the steam control knob to the minimum position. Set the temperature regulator to position "MAX".
2) When the indicator light goes off, turn the steam control knob to the suitable position. The steam will
come out from the holes in the soleplate. You can start ironing.
Burst of steam: Turn the temperature regulator to the position "MAX". The indicator light will go off when the
required temperature is reached. Then press the burst of steam button. The soleplate will spray out the
bursting steam.
"Burst of steam" can also be applied when holding the iron in vertical position, which is useful for removing
creases from hanging clothes, curtains, etc.
The iron surface must always be kept in an upright position.
To turn off, turn the temperature regulator counter-clockwise to "MIN" and pull out the power plug.
Turn the appliance upside down and carefully pour the remaining water out of the water tank. Carefully shake
the appliance.
Press the spray button to allow possible remaining water to come out more easily.
All manuals and user guides at all-guides.com
".
- 6 -