Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.3.3 - Connecting on the ADR IC1.x card
Each ADR IC1.x module provides connection for:
S
an STM1 interface (" TR " transmission port and " REC " reception port)
S
two order wire channels at 64 kbit/s (named "EOW" and "AUX"), which, by default, are
conveyed in E1 and F1 bytes of the SOH, respectively.
1.3.3.1 - Connecting STM1 interface
Remove the contact protection connector,
Connect STM-1 interface to front panel FC/PC connectors:
Ö
Transmission
Ö
Reception
"TR" and "REC" ports:
Interface Type
Bit rate
Standart
Encoding
Optical fiber*
Transmit optical power
Max. receive power
-10
Sensibility at 10
garanteed Attenuation
Typical range
Connector
* : It is possible to use a multi-mode optical fiber with diameter smaller than or equal to 62.5
microns. The optical budget is then reduced to 25 % of the optical budget obtained with a
mono-mode optical fiber. The transmission optical fiber is mono-mode type and the reception
optical fiber is multi-mode type.
1.3.3.2 - Connecting order-wire channels
"EOW" and "AUX" Interface:
Port
Bit rate
No reproduction or communication without the written consent of SAGEM SA
TR Connector
REC Connector
IC 1.1 = L 1.1 + S 1.1 or IC 1.2 = L 1.2 + S 1.2,
155.520 Mbit/s ± 15 ppm,
ITU-T G.957/G.958,
Not encoded (NRZ),
Single mode (1300 nm (IC1.1) or
1550 nm (IC1.2), ITU-T G.652),
-5 to 0 dBm
0 dBm
- 34 dB
0 - 28 dB with no external attenuator,
0 - 60 km (IC1.1) or 0 - 90 km (IC1.2),
all ceramic FC/PC
synchronous V.11 (differential),
64 kbit/s,
1 - INSTALLATION AND COMMISSIONING
Installation and User Guide - N56717020101
Page A1-13
Publicité
Chapitres
Table des Matières
