Glossary - Sony TC-KE600S Mode D'emploi

Additional Information
Inputs
Line inputs (phono jacks)
Sensitivity: 0.16 V
Input impedance: 47 kilohms
Outputs
Line outputs (phono jacks)
Rated output level: 0.5 V at a load impedance of
Load impedance: Over 10 kilohms
Headphones (stereo phone jack)
Output level: 0.25 mW at a load impedance of
General
Power requirements
Where purchased
U.S.A. and Canada
U.K., Continental
Europe, and certain
countries in Asia
Australia
Other countries
Power consumption
21W
Dimensions (approx.) (w/h/d)
430 × 120 × 310 mm (17 × 4
incl. projecting parts and controls
Mass (approx.)
4.6 kg (10 lbs 2 oz)
Supplied accessories
Audio connecting cords (2)
Optional accessory
Remote commander RM-J710
For more information on the availability of the remote
commander, contact your nearest Sony dealer.
Design and specifications are subject to change without
notice.
14 EN
47 kilohms
32 ohms
Power requirements
120 V AC, 60 Hz
220 - 230 V AC, 50/60 Hz
240 V AC, 50 Hz
120, 220, or 240 V AC, 50/60Hz
adjustable with the voltage selector
× 12
3 1
/ / inches)
4 4

Glossary

ATS
Automatic Tape Selection. The tape deck automatically sets
the appropriate equalization characteristics and bias current
according to the tape type inserted in the deck.
Bias calibration
Adjustment for optimum recording. You can get better
recording results with minimum distortion and flat
frequency response by adjusting the bias current to the
appropriate level. Lowering the bias current can boost high-
frequency response, but also cause higher distortion. On the
other hand, raising the bias current can minimize distortion,
but also reduce high-frequency response. To balance both
the bias current and high-frequency response, it is necessary
to adjust the bias current appropriately.
However, to suit your taste, you can also adjust the bias
current as you want.
dB
Output
level
400 3k
Dolby HX PRO system
Distortion and noise reduction system. The Dolby HX PRO
system reduces distortion and noise in high-frequency
response while recording. A tape recorded with this system
brings the same high-quality sound even when you play the
tape on the other tape decks.
Dolby NR (noise reduction) system
Noise reduction system for eliminating hissing noise. The
Dolby NR system boosts the low-level signals in high
frequency during recording and restores them during
playback.
There are 4 types in the Dolby NR system: A, B, C and S.
A-type is for professional use (not available on this tape
deck), and B, C and S-types are for consumer use. S-type has
the maximum noise reduction capability, followed by C and
B.
Dolby
dB NR off
B
Output
level
C
S
100 500 1k 5k
–
0
+
15k
Hz
noise reduction
Hz
10k
3-856-296-51(1)