MOB MO9379 Mode D'emploi page 5

All manuals and user guides at all-guides.com
2. Do not mix old and new batteries.
3. Install batteries with correct polarity.
CHARGE BATTERY OF QUADCOPTER:
1. Push the on/off switch of quadcopter to OFF position. Connect the charging port to a power supply device that has
the USB interface with the USB cable.
Charging light on, that is in the state of charge.
2. After charging for about 30 minutes, charging light goes off when full.
CAUTIONS WHEN CHARGING:
1. When charging, please put this product on a dried or ventilated area and keep it far away from heat source or
explosive product.
2. When charging should be supervised by an adult so as not to cause an accident.
3. After flying, please do not charge the Quadcopter if the surface temperature is still not cool. Otherwise it may
cause a swollen battery or even a fire hazard.
4. Please make sure that you use the original USB charging cable provided. When the battery has been used for a
long time, or appears to be swollen, please replace them.
5. A battery when not in use for a long time will lose its charge automatically. Charging or discharging too often may
reduce the life of the battery.
READY TO FLY
1. Unfold the quadcopter and place it on a horizontal position, then open up the power switch on the quadcopter.
When the indicator lights flash, it means that the quadcopter goes into the flight standby mode.
Note: The antenna of the transmitter must be aligned the tail of the quadcopter.