Häfele Dialock MDU Instructions De Service page 87

FAQs
During data exchange, the Dialock MDU displays the error "Terminal
offline". What should I do?
Make sure:
 that the terminal is in communication mode and that the Dialock
 that there are no objects between the Dialock MDU and the
In addition, the exchange of data is only possible with Häfele terminals fit-
ted with an infra-red interface or an adapter of the correct type.
During data exchange, the Dialock MDU displays the error "Wrong
terminal type". What should I do?
Ensure that the data to be exchanged correspond to the terminal type
(e.g. the Dialock MDU will not transfer door-terminal parameters to a wall
terminal).
Check the settings in the computer software Dialock Service and change
them if necessary.
Using the "complete solution" why can't I make terminal settings at
the Dialock MDU and then transfer them to the terminal?
In the "complete solution" terminals can only be controlled using the com-
puter software. Any settings or changes in terminal data must be made
using the computer software. In this type of system, the changing and set-
ting functions are not available in the Dialock MDU!
182_MDU_GB.indd 85
All manuals and user guides at all-guides.com
MDU is at a distance of approx. 10 cm from the terminal and that
cable between the terminal and Dialock MDU is correctly connect-
ed.
terminal.
Operating Instructions
Dialock MDU - status: 02.2006 - 732.29.182 85
24.02.2006 23:19:16