Publicité
Les langues disponibles
Les langues disponibles
WARNING !
!
Please read it carefully before assemble.
1.To AVOID SERIOUS INJURY: Never allow more than 2 player. Capacity 50kg max.
2.This activity toy is intended for outdoor use.
3.The minimum use zone for play equipment shall extend no less than 78.7 in. (2m) from
all sides of the play structure.
4.The maximum dropping height is 11cm.
Installation Instructions and Information
1.Place the equipment on level ground, not less than 2 m from any structure or obstruction
such as a fence, garage, house, overhanging branches, laundry lines, or electrical wires.
2.Do not install home playground equipment over concrete, asphalt, packed earth, grass,
carpet, or any other hard surface. A fall onto a hard surface can result in serious injury or death to the
equipment user. Activity toys should be installed over impact absorbing surface such as sand, wood-bark
chips, rubber and foam and should not be installed over concrete.
3.Please keep the assembly and installation instructions for further reference.
4.Do not modify the equipment.
5.Please tighten the nuts on bolts flush to the tube (or member) and that caps which go over
the exposed bolts shall be put on snug to the nut.
6.Children must not use the equipment until properly installed.
7.Continuous adult supervision required.
8.Always wear shoes when using the carousel.Observing the following statements and warnings reduces
the likelihood of serious or fatal injury.
9.Never allow more than 2 player. Capacity 50kg max. Excessive weight may cause a hazardous
or unstable condition.
10.Reminder that the toy should be used with caution since skill is required to avoid falls or
collisions causing injury to user or third parties.
11..Please retighten the screws after 14 days!
12Children are not allowed to walk close to, in front of, behind, or between moving items.
13.Children are not allowed to use the equipment in a manner other than intended.
14.Children are not allowed to get off equipment while it is in motion.
15.Children are not allowed to wear inappropriate items, such as but not limited to, loose fitting
clothing, hood and neck drawstrings, scarves, cord-connected items, capes and ponchos. These items can
cause death by strangulation.
16.Children are not allowed to climb when the equipment is wet.
17.Children are not allowed to attach items to the playground equipment that are not
specifically designed for use with the equipment, such as, but not limited to, jump ropes, clothesline, pet
leashes, cables and chain as they may cause a strangulation hazard.
18.Please let children to remove their bike or other sports helmet before playing on the
playground equipment.
19.Please dress children with wellfitting and full foot enclosing footwear. Examples of
inappropriate footwear are clogs, flip flops, and sandals.
Maintenance manual:
At the beginning of each play season:
1. Tighten all hardware.
2. Lubricate all metallic moving parts per manufacturer's instructions.
3. Check all protective coverings on bolts, pipes, edges, and corners. Replace if they are loose, cracked, or
missing.
4. Check all moving parts for wear, rust, or other deterioration. Replace as needed.
5. Check metal parts for rust. If found, sand and repaint using a nonlead-based paint meeting the require
ments of 16 CFR 1303.
6. Check all wood members for deterioration and splinters. Sand down splinters and replace deteriorating
wood members.
7. Reinstall any plastic parts that were removed for the cold season.
8. Rake and check depth of loose fill protective surfacing materials to prevent compaction and to maintain
appropriate depth. Replace as necessary.
9. Twice a month during play season:
10. Tighten all hardware.
11. Check all protective coverings on bolts, pipes, edges, and corners. Replace if they are loose, cracked, or
missing.
12. Rake and check depth of loose fill protective surfacing materials to prevent compaction and to maintain
appropriate depth. Replace as necessary.
Once a month during play season:
1. Lubricate all metallic moving parts per manufacturer's instructions.
2. Check all moving parts for wear, rust, or other deterioration. Replace as needed.
3. Remove plastic items as specified by the manufacturer and take indoors or do not use.
4. Rake and check depth of loose fill protective surfacing materials to prevent compaction and to maintain
appropriate depth. Replace as necessary.
5. Owners shall be responsible for maintaining the legibility of the warning labels.
6. Disposal Instructions—There shall be instructions advising the owner to disassemble and dispose of the
playground equipment in such a way that no unreasonable hazards will exist at the time the playground
equipment.
a) to check all nuts and bolts for tightness and tighten when required;
b) to oil all metallic moving parts;
c) to check all coverings for bolts and sharp edges and replace when required;
d) to check means of attachments for evidence of deterioration;
e) to replace defective parts in accordance with the manufacturer's instructions;
f) sand rust areas and tubular members and repaint using a non-lead based paint when required.
Consumer information sheet for playground surfacing materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground
equipment-related injuries resulting from falls to the ground surface are treated annually in US
hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all
playground injuries, and have the potential to be fatal, particularly when the injury is to the head. The
surface under and around playground equipment can be a major factor in determining the injurycausing
potential of a fall. It is self-evident that a fall on to a shock-absorbing surface is less likely to cause a serious
injury than a fall onto a hard surface. Playground equipment should never be placed on hard surfaces, such
as concrete or asphalt, and while grass may appear to be acceptable, it may quickly turn to hard-packed
earth in areas of high traffic. Shredded bark mulch, wood chips, fine sand or fine gravel are considered to
be acceptable shock absorbing surfaces when installed and maintained at a sufficient depth under and
around playground equipment.
Table B.1 lists the maximum height from which a child would not be expected to sustain a life-threatening
head injury in a fall on to four different loose-fill surfacing materials if they are installed and maintained at
depths of 150 mm, 225 mm and 300 mm.
Table B.1 — Fall height in millimetres from which a life-threatening head injury would not be expected
Type of material
Double shredded bark mulch
Wood chips
Fine sand
Fine gravel
However, it should be recognized that all injuries due to falls cannot be prevented, no matter what
surfacing material is used.
It is recommended that a shock absorbing material extend a minimum of 1 800 mm in all directions from
the perimeter of stationary equipment such as climbing frames and slides. However, because children may
deliberately jump from a moving swing, the shock absorbing material should extend in the front and rear of
-
a swing a minimum distance of twice the height of the pivot point measured from a point directly beneath
the pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-absorbing properties of various
materials. No particular material is recommended over another. However, each material is only effective
when properly maintained. Materials should be checked periodically and replenished to maintain correct
depth as determined necessary for the equipment in question. The choice of a material depends on the
type and height of the playground equipment, the availability of the material in a particular area, and its
cost.
This information has been extracted from the CPSC publications "Playground Surfacing — Technical
Information Guide" and "Handbook for Public Playground Safety".
Annex B
(informative)
Depth of surfacing material
150 mm
225 mm
300 mm
1 800
3 000
3 300
1 800
2 100
3 600
1 500
1 500
2 700
1 800
2 100
3 000
Publicité
