Replacing Carbon Brushes; After Use; Accessories - Makita LS1016 Manuel D'instruction

Cleaning of the lens for the laser light
For model LS1016L only
009609
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
Do not use solvents or any petroleum-based cleaners on
the lens.
009610
To remove the lens for the laser light, remove the saw
blade before removing the lens according to the
instructions in the section titled "Installing or removing
saw blade".
Loosen but do not remove the screw which secures the
lens using a screwdriver.
Pull out the lens as shown in the figure.
NOTE:
If the lens does not come out, loosen the screw
•
further and pull out the lens again without removing
the screw.

Replacing carbon brushes

001145
1. Screwdriver
2. Screw (one
piece only)
3. Lens for the
1
laser light
2
3
1. Lens for the
laser light
1
1. Limit mark
1
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
009516
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10
minutes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.

After use

After use, wipe off chips and dust adhering to the
•
tool with a cloth or the like. Keep the blade guard
clean according to the directions in the previously
covered section titled "Blade guard". Lubricate the
sliding portions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you
•
fully so that the slide pole is thoroughly inserted
into the turn base.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Steel & Carbide-tipped saw blades
•
24
1. Screwdriver
1
2. Brush holder
cap
2
or attachments
Only use accessory or
are