Bibby Scientific Stuart RE3011C Instructions De Service page 15

6.2.3
Test
Connect a vacuum measuring device to the suction connector and measure the ultimate
pressure.
If the device is working properly, then the figure stated in the technical data must be at-
tained within a maximum of one minute.
The pump must not make any abnormal noises.
Moving parts must not touch each other.
6.3 Maintenance by the Manufacturer
Repairs and maintenance going beyond the extent of the work described in chapter 6.2 or
reconditioning or modification may only be performed by the manufacturer or authorized
workshops.
The user shall be liable for the consequences of an incorrect damage report or a
contaminated pump. The statements in the damage report are legally binding.
6.4 Damage Report
You find the form of the damage report to the appendix of this manual.
Incomplete or incorrectly completed damage reports may endanger the service
personnel!
Give full information in the damage report, in particular regarding a possible con-
taminating of the sensor.
RE3011C
Maintenance and Servicing
WARNING !
WARNING !
15