Delabie 729008 Mode D'emploi page 6

FEATURES
• Pump-action liquid soap dispenser (the mechanism operates
by suction).
• The pump mechanism can be removed for maintenance or for refilling.
The upper part can be locked in place by a grub screw using a 3 mm
Allen key, which is supplied in a separate bag.
INSTALLATION (fig. C)
• Fit the tube over the mechanism's nozzle .
• Slide the tube and mechanism into the sheath .
• Insert the screw  and then tighten the bottle underneath .
INSTALLATION
ATTENTION: Do not use soapy water, detergents and acidic soaps
•
with a pH less than 6.
• Only use liquid soaps.
• Press the push-button slowly several times to evacuate the air out
of the tube.
• To avoid a long priming time for references 729150, 729112
& 729108, position the 5L soap reservoir at a maximum distance
of 600mm from the dispenser on a dedicated shelf (fig. A).
NB: The non-return valve should not touch the bottom of the tank.
Note: To avoid priming the dispenser after every refill, top-up the soap
in the reservoir before it is completely empty.
MAINTENANCE & CLEANING
Cleaning chrome: do not use abrasive, chlorine or any other acid-based
cleaning products. Clean with mild soapy water using a cloth or a sponge.
Clean the pump with hot water.
For the UK market only: Tel. 01491 821 821 - email: technical@delabie.co.uk
The installation guide is available on: www.delabie.co.uk
For all other markets: Tel. +33 (0)3 22 60 22 74 - email: sav@delabie.fr
The installation guide is available on: www.delabie.com
After Sales Care Support:
EN