Cleaning Mode - IMASS A3 Manuel D'utilisation

English
Operation
How to start cleaning
1
Assemble the docking station and switch on the
adapter. The signal lamp on the docking station
should start to flash.
Note: Place the docking station close to a wall and remove
obstacles approx. 1 m on both sides and approx. 2 m in
front of the device.
2
Switch on the power supply. The display should
now flash.
The robot vacuum cleaner switches to sleep mode if it
does not receive any commands within 16 seconds.
Note:
A. Make sure that the power switch is always turned on, as
the robot cannot be put into operation otherwise.
B. The selected mode is stopped if the power switch is
turned off.
Attention: Make sure that the power switch is turned on
before charging the robot, as the robot cannot charge
otherwise.
030
3
Charge the robot in a scenario as shown below:
A. Connect the plug to a socket.
B. Press the HOME button to send the robot back to the
docking station for charging.
To extend battery life:
A. Charge the robot overnight before using it for the
first time. The display field disappears when charging is
complete.
B. During normal use, always return the robot to the
docking station, which is connected to the power supply.
C. Fully charge the robot, then turn off the power switch
and place the robot in a cool, dry place if you will not use it
for a longer period.
4
Automatic charging
The robot automatically returns to the docking station
when the battery is low.
Start/pause/sleep
Sleep mode
The robot vacuum cleaner is not in operation. The
LED display on the clean button is turned off and
the power switch is on.

Cleaning mode

The robot vacuum cleaner is not in operation. The LED display on the clean button is illuminated.
1. Commissioning
A. Make sure that the power switch is turned on.
B. Press the CLEAN button on the main unit or the remote control to start cleaning.
Note: When the robot is in sleep mode, press the robot's CLEAN button to wake it up. The robot will immediately
start cleaning if you press the CLEAN button a second time.
2. Pause
Press the CLEAN button on the main unit or
the remote control to switch the robot from
cleaning mode to the selected mode.
Note: If you have paused the robot, press the
CLEAN button to restart cleaning.
English
Selected mode
The robot vacuum cleaner is not in operation. The
LED display on the clean button flashes.
3. Sleep
To switch the robot from the selected mode to
sleep mode:
A. Press and hold the CLEAN button on the
main unit for three seconds.
B. The robot automatically switches to sleep
mode if it does not receive a command within
15 seconds.
031