Subaru H001SFN100 Instructions D'installation page 8

SYSTEM REGISTRATION
10
ENSURE THE SOFTWARE VERSION HAS BEEN UPDATED TO THE LATEST REVISION
BEFORE ATTEMPTING SYSTEM REGISTRATION.
NOTE: Once the Ignition is turned ON, the system will exit System Registration after
2 minutes.
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
REGISTRATION
1. PRESS IMMOBILIZER ETC. REGISTRATION,
PRESS MMOBILIZER REGISTRATION AND
PRESS SELECT
PRESS
PRESS
FOR CAN
3. PRESS G TYPE FOR US KEY START MODELS,
OR PRESS I TYPE FOR CANADA KEY START
MODELS AND PRESS CONFIRMED
ISSUE
PART NUMBER
H001SFN100
PRESS
PRESS
PRESS
FOR US
PRESS
DATE
00
1 Jun 2022
Plug the DST-i
USB plug into a
Network-Enabled
laptop
2. PRESS IMPREZA/XV AND PRESS SELECT
Insert an ignition key
into the ignition
cylinder and turn to
the ON position
4. ENSURE THE IGNITION IS TURNED ON AND
PRESS OK
WAIT FOR LAPTOP TO
ESTABLISH CONNECTION
SUBARU OF AMERICA
Select/Open the SSM4
software on the
Network-Enabled
laptop
PRESS
PRESS
PRESS
8 OF 11