Subaru H001SFN100 Instructions D'installation page 3

4
VEHICLE PREPARATION, continued
5. Using a panel removal tool, carefully remove the upper
vent panel panel by pulling rearward to disengage
sixteen (16) pressure clips. Move the panel in the
direction of the arrow to release the hook and remove
the upper vent panel. (FIGURE E)
6. Using a panel removal tool, carefully remove the
ornament panel by starting at the back of the lower right
corner to disengage four (4) pressure clips and one (1)
fi nger clip. Pull rearward to remove the passenger's side
ornament panel. (FIGURE F)
7. Using a Phillips screwdriver, remove seven (7) Phillips
screws securing the glove box inner cover. Disengage
the six (6) pressure clips and disconnect the glove box
lamp connector to remove the glove box inner cover.
(FIGURE G)
PART NUMBER ISSUE
H001SFN100
DATE
00 1 Jun 2022
FIGURE E
FIGURE F
FIGURE G
SUBARU OF AMERICA
3 OF 11