Publicité
Installation Instruction
5
Kit contents
The following table lists the kit contents for the Danfoss heat shrink technology connection system:
1 x End-termination
heat shrink technology
for Danfoss PX / RX trace heaters
6
Installation
Preparation
Before installing any electric trace heating, the person installing must check if the trace heating has
been designed and planned correctly. It is particularly essential to verify the following points:
• complete project planning documentation, operating instructions and installation instructions.
• correct selection of the trace heater and accessories with respect to:
calculation of heat losses
max. permissible operating temperature
max. permissible ambient temperature
temperature class
heating circuit length
Before installing, make sure that all piping and equipment is properly installed and pressure tested.
5 | © Danfoss | 2021.11
End-termination - Heat shrink technology connection system
No.
Component
1
2
3
Qty.
Designation
Heat shrink tube for
1 x
end-termination
Outer heat shrink
1 x
tube for end-termi-
nation
Protection heat
2 x
shrink tube for end
termination
088L1457 & AN296061216351en-US0102
Dimensions
Length:
¾" (20 mm)
Diameter:
½" (12 mm)
Length:
2 ¾" (70 mm)
Diameter:
¾" (19 mm)
Length: 2 ⅓"
(60mm)
Diameter: ¾ "
(19mm)
Publicité
