Publicité
Installation Instruction
Table of contents
1
Overview 2
2
Certifications / Approvals 3
3
Technical data 3
4
Safety 4
5
Kit contents 5
6
Installation 5
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Required tools / equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Cautions and warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installation of the end seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
7
Troubleshooting 10
1
Overview
This manual introduces the installation and operation of Danfoss heat shrink splice technology. The
end-termination connection is sealed with heat shrink tubes.
Catalog No.: 088L1457.
Danfoss heat shrink splice technology can be used to establish end-termination.
It is suitable for the following self-regulating trace heaters:
• Danfoss PX Pipe Trace Heating System
• Danfoss RX-C Roof and Gutter De-Icing System
The following terms describe the parts of the trace heater within these instructions:
2 | © Danfoss | 2021.11
End-termination - Heat shrink technology connection system
bus wire
heating matrix
insulation jacket
grounding braid
outer jacket
088L1457 & AN296061216351en-US0102
Publicité
