Transportation, Storage And Disposal - Husqvarna K 770 Dry Cut Manuel D'utilisation

Masquer les pouces Voir aussi pour K 770 Dry Cut:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The blade guard extender and the
dust shield do not move freely.
The blade guard extender and the
dust shield do not move back when
the product is removed from the work
piece.
The fan does not operate.
Transportation and storage
Safely attach the product during transportation to
prevent damage and accidents.
Remove the cutting blade before transportation of
the product.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Keep the cutting blades in dry, frost free conditions.
Examine new blades for storage damage.
Remove the fuel from the fuel tank before long-term
storage.
Get support from your local fuel vendor for
information where to discard the used fuel.
Disposal
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
861 - 004 - 27.02.2019
Cause
The moving parts of the blade guard
extender and the dust shield are
clogged.
The springs of the blade guard ex-
tender and the dust shield do not op-
erate correctly.
The fan is blocked by foreign object.
The bearings are defective.
The fan belt does not have the cor-
rect tension.

Transportation, storage and disposal

Possible solutions
Clean the moving parts.
Do a check of the springs. Clean the
springs.
Remove the fan lid and remove the
foreign object that blocks the fan.
Do a check of the bearings.
Do a check of the fan belt.
31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

K 770 dry cut oilguard

Table des Matières