Uline SLIMFOLD H-4701 Mode D'emploi page 2

MOUNTING WITH SCREWS CONTINUED
3. Mark the four
holes on the wall
where screws will
be inserted using
template included in
box or by holding the
dispenser against the
wall. (See Figure 7)
4. Drill into wall at four
marked locations
with a 1/4" drill bit.
(See Figure 8) Insert
anchors into wall
(if applicable).
5. Hold dispenser to
mounting place and
insert screws into
previously drilled
holes using either a
screwdriver or a drill.
(See Figure 9)
PAGE 2 OF 9
All manuals and user guides at all-guides.com
MOUNTING INSTRUCTIONS CONTINUED
Figure 7
52" above floor
Figure 8
Figure 9
MOUNTING WITH ADHESIVE
1. Open wet wipe from
hardware pack.
(See Figure 10)
2. Wipe back of dispenser and wall with wet wipe.
(See Figures 11 and 12)
Figure 11
3. Remove backing from
adhesive strips.
(See Figure 13)
4. Place three strips on back of dispenser and
mount on wall. (See Figures 14-15)
Figure 14
Figure 10
Figure 12
Figure 13
Figure 15
0721 IH-4701