Ryobi R4SDP Traduction Des Instructions Originales page 17

Safety, performance, and dependability
have been given top priority in the
design of your screwdriver.
INTENDED USE
The screwdriver is intended to be
used only by adults who have read
and understood the instructions and
warnings in this manual, and can be
considered responsible for their actions.
The product is intended for fastening
and removing screws and bolts.
The product is intended for consumer
use only.
Do not use the product for any other
purpose. Use of the product for
operations different from intended could
result in a hazardous situation.
NOTE: It is recommended to use pilot
holes prior to driving screws.
WARNING
Read all safety warnings,
instructions, illustrations and
specifications provided with this
power tool. Failure to follow all
instructions listed below may result
in electric shock, fire and/or serious
injury.
Save all warnings and instructions for
future reference.
SCREWDRIVER SAFETY WARNINGS
■ Hold the power tool by insulated
gripping surfaces, when
performing an operation where
the fastener may contact hidden
wiring. Fasteners contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could give
the operator an electric shock.
■ Ambient temperature range for tool
during operation is between 0°C and
40°C.
■ Ambient temperature range for tool
storage is between 0°C and 40°C.
■ The recommended ambient
temperature range for the charging
system during charging is between
10°C and 38°C.
CHARGER SAFETY WARNINGS
■ Before using battery charger, read all
instructions and cautionary markings
in this manual, on battery charger,
battery, and product using battery to
prevent misuse of the products and
possible injury or damage.
■ Do not use charger outdoors or
expose to wet or damp conditions.
Water entering charger will increase
the risk of electric shock.
■ Use of an attachment not
recommended or sold by the battery
charger manufacturer may result in
a risk of fire, electric shock, or injury
to persons. Following this rule will
reduce the risk of electric shock, fire,
or serious personal injury.
■ Do not abuse cord or charger. Never
use the cord to carry the charger.
Do not pull the charger cord rather
than the plug when disconnecting
from receptacle. Damage to the cord
or charger could occur and create
an electric shock hazard. Replace
damaged cords immediately.
■ Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
moving parts or otherwise subjected
to damage or stress. This will reduce
the risk of accidental falls, which could
cause injury, and damage to the cord,
which could result in electric shock.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
English | 1