Télécharger Imprimer la page

Kärcher IVR-L 200/24-2 Tc Dp Mode D'emploi page 16

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
a Switch the device off and disconnect it
from the power supply.
b Move the device to the waste water
tank.
2. Connect the disposal hose to the waste
water tank.
3. Plug in the mains plug of the drum
pump.
4. Switch the drum pump on at the on/off
switch.
Note
Avoid dry running the drum pump.
Do not leave the drum pump unattended.
5. Adjust the flow rate with the +/- button.
Note
Only when emptying during vacuuming
operations:
Select the flow rate according to the vacu-
umed amount.
6. Dispose of or reuse the contents in ac-
cordance with statutory regulations.
Cleaning the liquid container
See graphics page for illustrations
Note
Bacterial contamination may occur through
the use of water-based cooling lubricants.
Wear suitable protective clothing when re-
moving deposits.
1. Empty the container.
2. Remove deposits in the container.
3. Dispose of the deposits in accordance
with the applicable regulations.
4. Remove chippings and deposits from
the support plates.
Illustration J
Removing the suction head /
preliminary filter cover
See graphics page for illustrations
1. Switch off the device and disconnect
from the power supply.
2. Open the lock for the suction head.
Illustration K
3. Open the lock for the preliminary filter
cover.
4. Remove the suction head and the pre-
liminary filter cover and put to one side.
16
Finishing operation
1. Switch off the device using the on/off
switch
2. Empty and clean the liquid container.
3. Remove the accessories and clean and
dry them as necessary.
Note
Empty the vacuum cleaner after every use.
Allow the vacuum cleaner to dry with the
container open.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
Care and service
1. Rinse off the device and accessories at
regular intervals using a suitable liquid
and allow to dry.
2. To prevent contamination, do not leave
fluids in the device.
3. For longer breaks in operation, open the
cover to allow the residual moisture to
evaporate.
4. Replace the filter if damaged.
Replacing the filter
See graphics page for illustrations
Illustration L
1. Unscrew the screw plug.
2. Remove and replace the filter.
3. Insert the new filter.
Ensure that the filter is inserted correctly
during installation.
4. Screw in and tighten the screw plug.
English
Transport
Storage

Publicité

loading