Table des Matières
Publicité
OPERATING INSTRUCTIONS
Charging Instructions
1.
Connect the charger plug to the charging jack or hole on the side of the sweeper.
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger
KA12D120015023U. (Fig. 2)
2.
This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
3.
When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4.
The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
5.
To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
Note:
If, when you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
Note:
Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important:
To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
Caution:
•
Use only the adaptor supplied with the sweeper.
•
Do not clean the sweeper while unit is charging.
•
Do not attempt to remove the battery pack from the unit to charge it.
•
Never attempt to throw the battery pack or unit into a fire or incinerate it.
•
Do not attempt to remove or damage the battery casing.
Charging
Light
Indicator
Fig. 2
4
CONSIGNES D'UTILISATION
Changer la brosse rotative, le boîtier de vitesse et la raclette
1.
Retirer le manche à tube d'extension de la tête motrice de la balayeuse.
2.
Retourner la tête motrice de la balayeuse à l'envers en faisant attention à ne pas
positionner l'appareil en mode " Marche ".
3.
Retirer le couvercle de la brosse.
4.
Appuyer sur la languette de fermeture du boîtier de vitesse et soulever le boîtier de
vitesse pour la retirer. (Fig. 12 et 13)
Languette
de
Boîtier
fermeture
de vitesse
Languettes du
boîtier de vitesse
Fig. 12
5. Tirer le bout du bouchon de la barre de la brosse vers le haut depuis la fente.
(Fig. 14)
6. Retirer la barre de la brosse de la zone de brossage et enlever la courroie pour
retirer la barre de la brosse. (Fig. 15)
7. Insérer la nouvelle barre de la brosse en insérant d'abord la barre de la brosse dans
le système de brossage sur l'extrémité contraire à la courroie conductrice. (Fig.15)
Tirer
Fig. 13
Fig. 14
Fig. 15
33
Publicité
Table des Matières
