Description Of The Controls; Technical Specifications - AEG BSS 4823 Mode D'emploi

Memory card slot (6)
1. Use the INPUT button (10) to select SD CARD mode.
2. Insert the memory card with the contacts facing up into
the appropriate slot. Playback will start after a few sec-
onds. The AUX indicator lamp flashes during playback.
For operation of the device, please refer to chapter "Descrip-
tion of the Controls".
CAUTION:
Select another operating mode before removing the
memory card.

Description of the controls

NOTE:
Depending on your playback unit, not all functions might
be supported.
(7)
You can pause and continue music playback. Press again to
continue playback.
(9)
Press 1 x = Restart of the song from the beginning. (Not
during USB/CARD mode)
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previous song.
(8)
Press to skip to the next song and the following songs.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause
Unit cannot Unit crashes and
be operated. "hangs".
Fault
No audio
signal via the
Bluetooth
connection
Speaker
cannot be
connected
Sharp
whistling
sound during
microphone
operation.
Battery cannot
be recharged.
No sound in
all operating
modes.

Technical Specifications

Model: .................................................................................BSS 4823
Power supply: ......................................................... AC 230 V, 50 Hz
Power Consumption:..............................................................100 W
Battery: ................................................................... 12 V 12000 mAh
Protection class: ................................................................................II
Net weight: .................................................................approx. 17 kg
Solution
Disconnect from the Microphones
mains for around Voltage supply: ...............................................2x 1.5 V type AA/R6
5 seconds. Then
Transmission frequency: ..................................636-865 MHz, UHF
switch the unit on
Channels: ...........................................................................................2
again. Power: ......................................................................................50 mW
Bluetooth
Bluetooth support: ........................................................V2.1 + EDR
Range: ..................................................................approx. 15 metres
Transmission frequency: ......................................2.402-2.480 GHz
Protocols: ....................................................................A2DP/AVRCP
Cause
Speaker is not paired
to the audio source.
Volume too low
Pairing does not
work
Audio source is
switched off
Bluetooth is switched
off at the audio
source.
Bluetooth version is
not supported.
Audio feedback
The battery has
been discharged
completely.
Input level too low.
................................................................ DC 12 V/5 A
Charging time: ............................................. approx. 11 hours.
Operating time: ................................................up to 36 hours.
English
39
Solution
Check whether a
connection exists. If
necessary, pair the
speaker again to the
audio source.
Increase the volume
on the speaker.
Increase the volume
on the audio source.
Check whether the
audio source supports
the A2DP protocol.
Switch on the audio
source.
Switch on the Blue-
tooth function in the
audio source.
Use a different play-
back unit.
Use the microphones
outside of the
speaker' s reverbera-
tion distance.
Charge the battery
using the DC-12 V IN
input (18).
Press and hold  but-
ton (8) to increase the
input level.