Publicité
Les langues disponibles
Les langues disponibles
Installation
WARNING: Do not exceed the electrical rating
printed on the data plate located on the upper left
side of the unit.
Location
Install the unit on a level area free from vibration. Refer to data
label on unit for more details about the installation clearance.
Do not position the equipment in direct sunlight or near
heating diffusers, radiators or other sources of heat.
Note: Do not move the unit in fully loaded condition.
Leveling the Unit
The refrigerator must be level in order to provide adequate
condensation drainage as well as proper door alignment and
operation. The refrigerator should be in its final operating
location and set so that it is firmly positioned on the floor.
Level the cabinet front to rear and side-to-side using the
corner leveling screws. The front leveling screws are
accessed by removing the base grill, as described below:
1. Remove the lower grill attachment screws
2. Grasp the grill with both hands
3. Lift the grill approximately 1/2"
4. Pull grill away from the refrigerator
Pallet Removal and Caster
Installation Instructions
Note: Casters available for all refrigerators (12, 25, 30, 45, 49
and 72 cu.ft.) and 25, 34, 49 cu.ft. freezers; leveling feet only
on 20 cu.ft. combo units.
CAUTION: Avoid damage to the refrigerant
tubing which may cause a refrigerant leak while
handling, moving, and operating this unit.
Note: It is recommended to install 2 casters with lock on the
front and 2 casters without lock on the back of the unit.
8 |
Installation
Without Forklift
Required Tools for Single Door Unit
(12, 25 & 30 cu.ft. models): Phillips head screwdriver,
7/16", 5/16"-18" wrenches, wrench supplied with unit and
follow local PPE and staffing procedures to remove the unit
safely.
Required Tools for Double and Triple Door Unit
(45, 49 & 72 cu.ft. models): Phillips head screwdriver,
7/16", 5/16"-18" wrenches and follow local PPE and staffing
procedures to remove the unit safely.
All the units are shipped with factory installed feet with rolling
casters supplied inside of the unit. The following instructions
demonstrate how to remove the cabinet from its shipping
base (pallet) and install the casters without use of a forklift.
CAUTION: The unit should be unpacked near
the desired location to avoid the risk of damage
while shifting.
1. Remove the packaging and kick plates from unit.
Remove additional packaging to access the interior of the
cabinet. Be sure to keep one cardboard corner for
subsequent step.
2. Using a screwdriver, remove the screws holding on the
front grill. Lift grill upwards and pull away from unit to
remove. Set aside.
Note: Re-install the front grill after placing the refrigerator in
the desired location and tighten the screws with a
screwdriver.
General Purpose and Chromatography Refrigerators
Publicité
