Publicité
Les langues disponibles
Les langues disponibles
B
Water Inlet Hose Connection
Your machine may have either a single water inlet connection (cold) or double water inlet
1
connection (hot and cold) depending on the machine specifications. The white capped hose
should be connected to cold water inlet and red capped hose to the hot water inlet (if applicable).
• To prevent water leaks at the joints, either 1 or 2 nuts (depending on your machine's
specifications) are supplied in the packaging with the hose. Fit these nuts to the end(s) of the
water inlet hose that connect to the water supply.
Connect new water inlet hoses to a ¾ ˝, threaded tap.
2
• Connect the white capped end of the water inlet hose to the white water inlet valve on the
rear side of the machine and the red capped end of the hose to the red water inlet valve (if
applicable).
• Hand tighten the connections. If in any doubt, consult a qualified plumber.
• Water flow with pressure of 0. 1-1 Mpa will allow your machine to operate at optimum
efficiency (pressure of 0. 1 Mpa means that more than 8 litres of water per minute will flow
through a fully opened tap).
3
Once you have made all of the connections, carefully turn the water supply on and check
for leaks.
Ensure that the new water inlet hoses are not trapped, kinked, twisted, folded or crushed.
4
• If your machine has a hot water inlet connection, the temperature of the hot water supply
should not be higher than 70°C.
Using the appliance
3/4"
1
3
8
EN
2
4
Publicité
