Lighting - Real Flame Restoration Hardware 26100238 Manuel Du Propriétaire

Using the ignitor
1. Read and understand all operating instructions before lighting. Ensure that all
protective film has been removed from stainless burn tray prior to lighting.
2. Burner control knob must be in the "OFF" position.
3. Connect propane (LP) cylinder (see above pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use
your other hand to push and turn the control knob
to the "LIGHT" position to light the burner.
7. Keep Burner Control Knob pressed in for 15-30 seconds after ignition.
After lighting, rotate the Burner Control Knob counter clockwise to "Low" setting.
9.
Observe flame, make sure all burner ports are lit. Flame height should be no higher than
13 inches tall.
10. Adjust the flame to the desired height with the
control knob .
Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move the lava rocks
for access to the burner.
2. Wearing heat resistant gloves, position
the burning long match or burning butane
lighter near the side of the burner. DO NOT
lean over the firetable while lighting!
3. Turn control knob counterclockwise to "LIGHT".
4. Remove long match/long butane lighter.
5. After lighting, use a shovel and heat resistant
gloves to carefully move the lava rocks back into
their proper position.
6 . After lighting, rotate the Burner Control Knob
counter clockwise to "Low" setting.
Observe flame, make sure all burner ports are lit.
Flame height should be no higher than
13 inches tall.
7. Adjust the flame to the desired height with the
control knob.
!
WARNING
If burner flame goes out during operation,
immediately turn the control knob "OFF" and let the
gas clear a minimum of 5 minutes before attempting
to re-light the fireplace.
Please refer to the trouble shooting pages for
additional support, beginning on page 18.
14
All manuals and user guides at all-guides.com
Lighting Instructions
!
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
OFF
PUSH
IN
8
Control Knob
HI