Pre-Use Instructions; Checking For Leaks - Real Flame Restoration Hardware 26100238 Manuel Du Propriétaire

Pre-Use Instructions

7
!
WARNING Before using this outdoor fire table, make
sure you have read, understand and are following all
information provided in the Important Safety Information
section of this manual. Failure to follow those instructions
can cause death, serious injury or property damage.
Prior to each gas fire table operation, check the hose and
valve for evidence of excessive abrasion or wear though
the visual check hole on the side of the base. Replace
visual check cap prior to operating fire table.
BURNER CONNECTIONS
Make sure the regulator valve and hose connections are
securely fastened to the burner and the tank. If your unit
was assembled for you, visually check the connection
between the burner pipe and orifice. Make sure the burner
pipe fits over the orifice.
!
Warning: Failure to inspect this connection or follow
these instructions could cause a fire or an explosion,
which can cause death, serious bodily injury, or damage
to property.
Please refer to diagram for proper installation.
If the burner pipe does not rest flush to the orifice please
contact Real Flame at 1-800-654-1704 for assistance.

CHECKING FOR LEAKS

Make a leak check solution by mixing 1 part dishwashing
soap with 3 parts water in a sprav bottle.
Ma ke sure control knob is "OFF." Then, turn LP gas tank
to "ON" at valve.
Spray leak solution on valve connections paying particular
attention to the areas indicated by arrows.
If any bubbles appear turn LP gas tank OFF, reconnect and
re-test. If you continue to see bubbles after
several attempts, disconnect LP gas source and
contact Real Flame at 1-800-654-1704 for assistance.
If no bubbles appear after one minute turn tank OFF, wipe
away solution and proceed.
All manuals and user guides at all-guides.com
Burner Pipe
Check for leaks at these locations
13