Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Important! Before starting the installation, please ensure that all devices are powered off.
The following steps are for an installation using HDMI equipment, if you are using DVI equipment, please
substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the HDMI Extender Transmitter unit using a HDMI cable (maximum
length 2m).
2. Connect one end of the Cat.5e/6/7 cable (max. length 70m) to the HDBaseT port on the Transmitter
and the other end to the HDBaseT port of the Receiver. Use solid core installation cable of at least
Cat.5e UTP.
3. Use another HDMI cable (maximum length 2m) to connect your HDMI display device to the HDMI
output port on the Receiver unit.
4. For additional Infrared remote signal functionality, connect the included IR
Emitter cables to the IR OUT ports and the IR Receiver Cables to the IR IN
ports on both the Transmitter and Receiver units.
5. The IR Emitters should be placed in front of the IR receiver of the devices
which are to be controlled. The IR Receivers should be located where they
may easily receive the signal of your IR remote.
6. Plug the DC power supply into the Transmitter and switch on.
7. Power on your HDMI Source and Display to complete the installation.
Troubleshooting
There is no display on the screen.
▪
Check that the DC plug and jack used by external power supply is firmly connected and screwed on
securely
▪
Check that the Cat.5e/6/7 cable is plugged in correctly and that the Link Status LED is lit.
▪
Check that the HDMI source and display are both powered on and active
▪
Power off all the devices, then power on in this order: first, the transmitter unit, then the display and
finally the source.
▪
For several HDMI devices it may be helpful to unplug and replug their HDMI connection to re-initiate
the HDMI handshake and recognition.
▪
Reduce the length of Cat.5e/6/7 or HDMI cable used, or use a higher quality cable.
General Guidelines
▪
If you are terminating the Cat.5e/6/7 yourself, ensure that you untwist less than 13mm of cable to make
the connection; otherwise you may introduce cross-talk which will affect the performance of the
Extender.
▪
Do not twist, kink or over extend the Cat.5e/6/7 cable, and ensure that its minimum bend radius is
observed (usually this is 4 x the outer dimension of the cable).
▪
Do not use excessive force when pulling the cable.
English
IR Emitter IR Receiver
Publicité
