HBM Machines 10535 Manuel D'instructions page 40

Electrical connection
The electrical motor installed is connected and ready for operation. The connection complies with the ap
plicable VDE and DIN provisions.
The customer's mains connection as well as the ex- tension cable used must also comply with these reg
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of- ten damaged.
This may have the following causes:
Pressure points, where connection cables are passed through windows or doors.
Kinks where the connection cable has been improperly fastened or routed.
Places where the connection cables have been cut due to being driven over.
Insulation damage due to being ripped out of the wall outlet.
Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and are life-threatening due
to the insulation damage.
Check the electrical connection cables for damage regularly. Ensure that the connection
cables are dis- connected from electrical power when checking for damage.
Electrical connection cables must comply with the applicable VDE and DIN provisions.
Only use connection cables of the same designation.
The printing of the type designation on the connection cable is mandatory.
For single-phase AC motors, we recommend a fuse rating of C 16A or K 16A for machines
with a high starting current (from 3000 watts)
Cleaning
Attention!
Disconnect the mains plug before carrying out any cleaning work.
We recommend that you clean the device directly after every use and checked the filers
which was damaged or not.
Wipe swarf and dust off the machine from time to time with a cloth.
Clean the device at regular intervals using a damp cloth and a little soft soap. Do not use any cleaning