HBM Machines 10535 Manuel D'instructions page 36

Follow all these instructions before and while working with the machine.
Store these safety instructions safely.
Protect yourself from electric shock! Avoid physical contact with earthed parts.
Unused devices should be stored in a dry, locked place and out of reach of children.
Keep tools sharp and clean in order to be able to work better and more safely.
Check the cable of the tool regularly and have it re- placed by a recognised specialist when damaged.
Check extension cables regularly and replace them when damaged.
Only use extension cables that have been approved and appropriately labelled for use outdoors.
Pay attention to what you are doing. Remain sensible when working. Do not use the tool when you are
fatigued.
Do not use any tools on which the switch cannot be switched on and off.
Warning! The use of other insertion tools and other accessories can entail a danger of injury
Pull out the mains plug for any adjustment or repair tasks.
Pass the safety instructions on to all persons who work on the machine.
Before commissioning, check that the voltage on the device type plate corresponds to the
mains voltage.
If an extension cable is required, make sure that its cross-section is sufficient for the
current consumption of the device. Minimum cross section 1.5 mm 2 .
Only use the cable drum when unrolled.
Check the mains connection cable. Never use any faulty or damaged connection cables.
Do not use the cable to pull the plug out of the out- let. Protect the cable from heat, oil and
sharp edges.
Do not expose the machine to rain and do not use the machine in a damp or wet
environment.
Ensure good lighting.
Do not use in the vicinity of combustible fluids or gases.
When working outdoors, anti-slip footwear is recommended. Tie long hair back in a hair net. Avoid
abnormal posture
The operating person must be at least 18 years of age; trainees must be at least 16 years, however only
under supervision.
Keep children away from the device when connect- ed to the mains.
Keep the workplace free of wood debris and parts lying around.
Disorder in the work area can lead to accidents.
Do not allow other persons, especially children, to touch the tool or the mains cable. Keep
such per- sons away from the workplace.
Personnel working on the machine must not be distracted.
Only carry out modifications, adjustment, measuring and cleaning work when the engine is
switched off. - Pull out mains plug –
Before switching on, make sure that keys and adjusting tools are removed.