Lubrication - Power Fist 8823304 Manuel D'instructions

V1.0
6. Thread the cable end through the swivel opening and into remaining
ferrule opening.
7. Crimp the ferrule to secure cable. Ensure there is enough pressure to
prevent the cable from pulling out of the ferrule.
8. Thread the remaining cable through the hook' s pulley, under the cable
guide and onto the drum.
9. Insert the cable end into the drum key hole and pull the handle to
wrap three turns of cable onto the drum.
10. Attach the tool to an anchor point and a load that will place tension on
the cable. Pull the load towards you and carefully guide the wraps
until the cable is wrapped neatly on the drum.
11. Detach from the anchor and load.
CLEANING
Wipe the tool with a clean cloth and periodically blow out all areas with
compressed air. If compressed air is not available, use a brush to remove
dust from areas. Do not use harsh chemicals or solvents to clean the tool.
CABLE CLEANING
A cable will accumulate debris over time. This debris can act as an abrasive
on the cable and damage it.
Spread the cable out on a clean surface and spray it clean with a garden
hose. Scrub the wire strand cable with a wire brush to loosen dirt and rinse.
Commercially available cleaners may also be used. Dry the cable with
compressed air.

LUBRICATION

Inspect and lubricate the tool when required. Only use light oil to lubricate
the tool. Other lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
Bend the cable to spread the strands and apply a penetrating lubricant.
Application can be done with a spray or bath. Allow time for the lubricant to
soak into the cable. Multiple lubricant applications may be required. Wipe
off any excess lubrication once the task is complete.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
Visit www.princessauto.com for more information
1 Ton Cable Puller with 2 Hooks 8823304
7