Power Fist 8823304 Manuel D'instructions page 5

V4.0
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the Identification Key are included.
IDENTIFICATION KEY
A Anchor Hook
B Stop Pawl
C Ratchet Drum
D Drive Pawl
E Drive Pawl Spring
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
1. Hook the cable hook (I) onto the load or pulling device (straps, chains,
etc.) and check that the latch is shut.
2. Press down on the drive pawl spring (E). The end of the spring will
slide to the slot' s bottom and raise the drive pawls (D).
3. Push the handle forward towards the cable hook (I). Push the stop
pawls (B) away from the ratchet drum' s teeth.
4. Pull out the amount of cable desired, leaving a minimum of three
wraps on the drum. Release the stop pawl and move the handle to the
start position.
Visit www.princessauto.com for more information
1 Ton Cable Puller with 2 Hooks
F Cable Guide
G Swivel
H Cable
I Cable Hook
J Handle
8823304
5