Care & Maintenance - Power Fist 8823304 Manuel D'instructions

8823304
5. Clip the anchor hook (A) to the sturdy object capable of withstanding
the strain. Make sure the latch is fully shut.
6. Press upward on the drive pawl spring (E) to engage the drive pawls
with the ratchet teeth.
7. Raise the handle to force the pawls into the ratchet teeth and advance
the spool to draw the cable onto the puller' s drum. Lower the arm to
reset for the next pull.
8. Repeat until the load reaches its final position. Check that the cable is
wrapping neatly on the drum. Do not allow it to pile up on one side or
to overlap in the middle.
9. Disengage the pawls (steps 2 and 3) and pull the cable puller to release
the cable tension. Disengage the cable hook and anchor hooks.
10. Recover the remaining cable onto the drum.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when
servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CABLE REPLACEMENT
1. Pull the entire cable off the drum.
2. Remove the cable from the drum' s keyhole.
3. Pull the cable through the cable guide (F) and the hook' s pulley.
4. Cut the cable between the swivel (G) and the ferrule. Remove the cable
5. Slide a new ferrule onto the cable end.
6
1 Ton Cable Puller with 2 Hooks
For technical questions call 1-800-665-8685
V1.0