Installing Batteries; Using Headphones - Mr. Blacksmith 8968463 Manuel D'utilisation

Caution:
•
The search coil's plug fits into the connector only one way. Do not force the
plug or you could damage it.
•
Do not over tighten the search coil or use tools such as pliers to tighten
it.

INSTALLING BATTERIES

1. Turn off the power before installing the batteries.
2. Slide the left and right battery covers off in the direction of the arrow.
3. Place two 9V batteries into the battery compartment matching the polarity
symbols (+ and -) marked inside.
Cautions:
•
Use only fresh alkaline batteries of required size.
•
Do not mix the old and new batteries or different types of batteries.
•
Dispose of old batteries promptly and properly. Never bury or burn
them.
• If you don't plan to use the unit for a week or more time, remove the
batteries. Batteries can leak chemicals that can destroy electronic parts.

USING HEADPHONES

1. Insert the headphones'3.5mm plug into the PHONE jack. At this time the
internal speaker disconnects.
2. Set the VOLUME to the desired level.
Listening Safely
•
To protect your hearing, set the volume to the lowest setting before you
begin listening, adjust the volume to a comfortable level.
•
Do not wear headphones while operating your detector near high-traffic
areas. Pay attention to traffic safety.
4