Mr. Blacksmith 8968463 Manuel D'utilisation page 2

With your metal detector, you can hunt for coins, relics, jewelry, gold, and
silver just about anywhere. The detector is versatile and easy to use.
The detector's features include:
--
LCD Display shows the probable type of metal with an arrow, the depth of the
target, DISC range, the level of SENS with segment, the operating mode, and
battery indication.
Three Tone Audio Discrimination
types of metal.
DISC --
ignores junk metal and finds valuable items by setting the DISC
range.
P/P --
pinpoints the accurate location of the target detected.
Headphone Jack (3.5mm)—
and operate without trouble.
Power—
requires two 9V alkaline batteries(not supplied)
waterproof Search coil—
under water.
PREPARATION
ASSEMBLING THE DETECTOR
Assembling your detector is easy and requires no special tools. Just follow
these steps.
1. Insert the coil cable plug into the 5 pin jack connected with S stem .
Sheathe the lower stem on S stem and secure with the fixing knob.
Turn the stem's lock nut clockwise until it loosens.
Lengthen or shorten the stem so when you stand upright with the detector in
your hand, the search coil is level with and about one half to 2 inches above
the ground with your arm relaxed at your side.
--
sounds distinctive tones for different
lets you connect headphones (not supplied)
lets you use the detector even if you must put lt
2