Mr. Blacksmith 8968463 Manuel D'utilisation page 3

Then turn the stem's lock nut counter clockwise to lock it in place.
Loosen the knobs at the search coil's end, then adjust the search coil to the
desired angle.(The search coil should be parallel with the ground.) Tighten the
knobs just enough to keep the search coil from rotating or wobbling.
2. Insert the latch on the top of the handle into the assembly hole on the
bottom of the control box. Then slightly push the control box in the
direction of IN marked on the handle to fix the latch in place, Secure the
control box with fixing screw properly.
3. Unscrew the knob on the search coil and remove the knob connector.
Insert the stem and align the holes on the search coil bracket and the
stem. Push the connector through the holes and tighten the knob.
4. Wind the search coil cable around the stem. Leave enough slack in the
cable. Insert the search coil cable plug into the five pin jack on the front
control box's housing.
5. Turn the stem's lock nut clockwise until it loosens. Lengthen or shorten so
when you stand upright with the detector in your hand, the search coil is level
with and about 1/2 to 2 inches above the ground with your arm relaxed at
your side. Turn the stem's lock nut counter-clockwise to lock it in place.
3