Axis PT IR Illuminator Kit A Guide D'installation page 11

PT IR Illuminator Kit A Installation Guide
12. Make sure the photocell potentiometer on each Illuminator is turned to its maximum setting (+)
13. If required, turn the power potentiometer on each illuminator to adjust the light intensity.
1 Illuminator cable (red, black)
2 Photocell potentiometer
14.Put the potentiometer caps back in their original places.
The potentiometer caps must be in place to maintain the product's IP66 rating.
15. Attach the top cover to the bottom cover. Make sure to tighten diagonally opposite bottom cover screws a
few turns at a time until all are tight (torque 4 Nm). This will help ensure that the bottom cover gasket is
compressed evenly.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
1
2
3
4
3 Power potentiometer
4 Potentiometer cap (2x)
Page 11