krispol STARCUS F50 Manuel D'installation page 59

SETTINGS OF FUNCTION PARAMETERS IN MENU
1. 3
Correction of the
CLOSE travel limit
position
Note:
By default
- 5
- select from
the limit position in the opening direction
- select
the limit position in the opening direction.
1. 3
Press and hold the SET button for about 6 se-
conds until the display shows 0.- then release
the button
- use the + button to select 1.- then shortly
press the SET button to select this parameter
- 1.0 appears on the display
- use the + button to select 1.3
- 5
Then shortly press the SET button;
flashing on the display; select the parameter
in the range from
buttons; then shortly press the SET button to
select this parameter and automatically go
1.3
to
Note
By default
- select
limit position towards closing.
- select
limit position towards the centre of the door.
- 5
0 F
to which means changing
- F 0
to which means changing
- F 0
2.-
0 F
to which means changing the
-F 0
to which means changing the
-5
starts
F
to using the +/-
59