Watts TRITON TRCU1 Guide De L'utilisateur & Manuel D'instructions page 16

All manuals and user guides at all-guides.com
Equipment Setup & Usage Instructions
Fusing a Fitting
STEP 2
Prepare Fitting for Fusion
NOTICE
Unpack Fitting carefully and check
for any shipping or transportation
damage. Do not use Fitting if any
damage is found—repackage Fitting
and return it to purchase place for
repair or replacement.
NOTICE
Failure to insert pipe into Fitting
to required depth will produce an
improper joint which can result in
leaks. Such leaks may even exist
causing property damage.
under lever tongue (C) and pushing
upwards.
Note: Each Fitting is designed so that the Fuser jaws will only fit on the assembly
and close in the correct position on the weld zone.
accommodate for tight spaces.
STEP 3
Activate Fuser
by depressing the lever tongue.
release to initiate fusing process.
Note: The Control Unit automatically senses ambient temperature and will
automatically adjust the fusion time as necessary.
14
(continued)
surement guide (located on each Fitting)
and make small scratch using thumbnail
or line with pencil to mark for insertion
depth as shown (B). Orient Fitting (as
needed) and insert pipe into Fitting to
required depth.
C
jaws properly positioned in weld zone.
B
-
D