Panasonic ER-GC70 Mode D'emploi page 4

AC operation
You can use the clipper while charging, even if the battery
capacity is low.
If the clipper does not work, continue charging it for approx. 1
minute.
Using
Using comb attachments
1. Slide the power switch on the main body to
the "0" position to turn off the clipper.
2. Make sure there is no damage to the blade.
3. Mount the attachment and adjust the dial.
• See pages 4 and 5.
4. Slide the power switch on the
main body to the "1" position to
turn on the clipper.
After adjusting the trimming length,
make sure the attachment is fixed with
the switch in the "1" position. When
the attachment is mounted correctly,
the dial will not turn with the switch set
to "1".
5. Cut hair to the correct height by
moving the clipper back against the
flow of the hair.
Do not use the clipper in an inverted position.
This can cut hair too deeply.
► Trimming without attachment combs
Trimming your hair without an attachment will trim hair length to
approx. 0.5 mm.
4
1. Cut hair by placing the clipper head
directly on the scalp.
Installing the attachment comb
Comb attachment [A] (1 mm to 5 mm)
1. Align the 2. Mount the
instruction comb
mark " " to attachment [A]
"1". to the main
body.
Cutting length (mm)
1
(estimate)
Scale marks 1
• The dial will turn past the indicator "6" even when the comb
attachment [A] is being used. The clipper will not cut well above
6 mm, so do not try to cut more than 6 mm with the comb
attachment [A] mounted.
• Actual hair length will be a little longer than the height you set.
3. Align the
instruction
mark " " to
the length you
want to cut.
 3 4 5
 3 4 5