Care And Maintenance - NODOR V24B Manuel De L'utilisateur

Temperature Display
During normal operation, the temperature display on
the control panel shows the temperature inside the
appliance. The temperature display will flash if
- A different temperature is being set,
- The temperature in the zone deviates by more
than 5°C from the set temperature. The
temperature display flashing ensures that the temperature can
not rise or fall un-noticed and impair the wine.
Shelves
• To prevent damaging the door gasket, make
sure the door is fully open when pulling shelves
out of the rail compartment.
• For easy access to the bottles stored, pull the
shelves out approximately 1/3. The shelves are
designed with an emergency stop to prevent
them being removed too far when loaded.
Defrosting
• The unit defrosts automatically.
• The evaporator behind the rear wall of the unit
defrosts automatically. The condensate collects
in the drainage channel behind the rear wall of
the unit, and flows through the drainage hole
into the drip tray by the compressor where it
evaporates.

Care and Maintenance

Removing Shelves
• To remove any of the shelves from the rail
compartment, move the shelf to the position
where the notch on the shelf is exactly under the
plastic post then lift the shelf to release it. When
replacing the shelves, always ensure they are
correctly located.
Humidity Control (Optional)
• The wine cooler is equipped with a system for
maintaining the correct level of humidity. Fill
the small plastic reservoir (humidity box) ¾ full
with water, and fit onto the runners found on
the top shelf of the wine cooler. Check the
water level regularly and refill as necessary.
• Please ensure the reservoir is positioned
correctly on the runners on the top shelf to