The Controls Of Your Wine Cooler - NODOR V24B Manuel De L'utilisateur

and lower hinge plate 7 into the door. Make
sure that the spacers which the hinge pins sit
on are correctly positioned.
6. Leveling the door by adjusting the screws that
are used to fix the top hinge plate and lower
hinge plate.
OPERATING YOUR WINE COOLER
The Wine Cooler should be placed in a position
where the ambient temperature is between 16-
35°C/60~95ºF. If the ambient temperature is above
or below this range, the performance of the unit may
be affected. For example, placing your unit in
extreme cold or hot conditions may cause interior
temperatures to fluctuate. The range of 5-
22°C/40~72ºF may not be reached. (In-Column)
The range of 5-18°C may not be reached. (Built-in)
Note
:
• When you use the Wine Cooler for the first time or
restart the Wine Cooler after having been shut off for a
long time, there could be a few degrees variance between
the temperature you select and the one indicated on the
LED readout.
This is normal and it is due to the length of the activation
time. Once the Wine Cooler is running for a few hours
everything will be back to normal.
• If the unit is unplugged, power lost, or turned off, you
must wait 3 to 5 minutes before restarting the unit. If you
attempt to restart before this time delay, the Wine Cooler
will not start.
USE AND CONTROL – V24B

The Controls of Your Wine Cooler

POWER
To control this appliance turn on/off. To turn OFF the
appliance, press the button and hold 5 seconds.
LIGHT
To control the inner light turn on/off.
UP
Used to increase (warm) the set temperature by
1°C/1ºF.
DOWN
Used to lower (cool) the set temperature by 1°C/1ºF.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit
or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit,
press the and
seconds.
Setting the Temperature Control
• You can set the temperature as required by
pressing the UP or DOWN button. When you
press the two buttons for the first time, the LED
readout will show the original temperature set
previously (the temperature preset at the factory
is 12°C/54 ºF).
• The temperature will increase 1°C/1ºF if you
press the UP button once, or the temperature
will decrease 1°C/1ºF if you press the DOWN
button once.
• To view the "set" temperature at any time, press
the UP or DOWN button, the "set" temperature
will temporarily "flash" in the LED display for 5
seconds.
• The internal storage temperature will appear in
blue color in the temperature display window.
buttons at the same time for 5