Before Use - Taurus 990551 Mode D'emploi

ensuring that the positive and negative poles are
alligned with the symbols on the scale. Caution:
During the handling of batteries, do not touch
both poles at the same time, as this will provoke
the partial discharge of the stocked energy there-
fore affecting longevity.
2.4.5. Replace the cover of the battery compart-
ment.
2.4.6. It is essential that the batteries should
always be the same kind and the same charge.
Never mix alkaline batteries with standard one
(Carbon- Zinc) and/or rechargeable ones.
2.4.7. N.B. When changing the batteries, the
configuration of the appliance will be removed,
and you will need to reset the parameters of the
appliance.
3. Instructions for use

3.1. Before use:

3.1.1. Remove the appliance's protective film (if
applicable).
3.1.2. Before using the product for the first time,
clean the parts that will come into contact with
your skin in the manner described in the cleaning
section.
3.2 Use and care:
3.2.1. Remove the battery compartment cover.
3.2.2. Check that the plastic covering that protects
the battery has been removed (some batteries are
sold with a protective covering) this scale uses a
3V CR2032 lithium battery (included).
3.2.3. Put the battery in its compartment. Insert
the Lithium battery (Included).See figure 1 (Note:
Make sure battery is pushed all the way into its
slot). Also make sure the "+" side of the battery
is facing out.
Caution: During the handling of batteries, do not
touch both poles at the same time, as this will
provoke the partial discharge of the stored energy
therefore affecting longevity.
3.2.4. Select the weight unit by either pushing the
weight unit selector lever to the far right (lb) or the
far left (kg).
3.2.5. Replace the cover of the battery compartment.
3.2.6. Place the scale on a hard flat surface. Do
not use the scale on a carpet as the reading will
be inaccurate. Step on the scale and step off to
switch it on. The digit "0.0" will be displayed.
20502B_IM.indd 3
3.2.7. If you step on the scale before "0.0" appears,
you will not obtain a reading. If this happens, step
off the scale then wait for the display to turn off
and follow the above steps again.
3.2.8. To measure your weight, simply stand on
the scale with both feet. Be sure to stand erect and
remain still. After a few seconds the display will
flash your weight and remain locked in for a few
seconds. The scale will switch off automatically
after a few seconds after use. Please Note: if a
weight less than 3KG is placed on the scale, the
scale will not activate.
3.2.9. If the scale has not been used for a long-
time, proceed as follows:
may use the scale normally.
check if the battery and the contact point is well
connected. If scale has not been in use for a long
time, replace the battery and try again
4. Cleaning and Maintenance
4.1. Clean the equipment with a damp cloth with
a few drops of washing-up liquid and then dry.
4.2. Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support
centre if product is damaged or other problems
arise.
5.2. If the connection to the mains has been
2020/12/10 09:15:51