Finishing The Installation; Using Your Ceiling Fan; Setting Dip Switches - Fanaway Corbelle Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fanaway Corbelle Installation Instructions
9.
Turn the connecting nuts upward and push the wiring into the outlet box.
10. Carefully insert the Remote Receiver above the hanger ball in the remainder spacing in the
mounting bracket. Take care not to damage or loosen any of the wiring.
Slide and align the canopy up to the mounting bracket. Ensure all electrical wiring is tucked inside the
canopy and that the wires are not damaged during this step. Secure the canopy to the hanger bracket
using the screws provided.

SETTING DIP SWITCHES

When two or more fans are located near each other, you may desire to have the receiver/transmitter for
each fan set to a different code, so that the operation of one fan does not affect the operation of the other
fans.
The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the
transmitter are in the battery compartment. Fig. 13.
NOTE: Ensure that the power to the supply wires has been turned off before setting the code.
Fig. 13
Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the
DIP switches match in the remote receiver and transmitter. If they don't match, the transmitter will not
function. Fig. 14
9 | P a g e

FINISHING THE INSTALLATION

Fig. 12

USING YOUR CEILING FAN

Fig. 14
V e r s i o n 1 . 0
I N D U S T R I
0 4 / 2 0 2 1

Publicité

Table des Matières
loading

Table des Matières