Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fanaway Corbelle Installation Instructions
Fig. 6.5
6. Insert the decorative cover (7) onto the down rod (6) to cover the down rod coupling housing (8).(Fig. 6.5)
7. Insert the canopy (5) over the down rod (6) and install the ball joint (2) and dowel pin (3) back onto the
down rod (6) and secure by tightening the set screws (4). (Fig. 6.5 and Fig. 6.6)
LIGHT KIT INSTALLATION (Fig.7 & 8)
1. Loosen the screw (1) from the fan bracket. Align the two slot screws with the keyhole slots (2) of the
light kit plate. (Fig. 7)
2. Turn the light kit plate counterclockwise until the slot screws are firmly at the end of the slots (2).
3. Secure screw (1) to the light kit plate. Tighten all three screws. Do not over-tighten.
4. Connect the quick connector to the lamp holder part (3). (Fig. 8)
5. Secure the lamp-holder part (3) to the light kit plate by tightening the 3 screws. Do not over-tighten.
6. Install the globes (4) to the lamp holders. Do not exceed the maximum power rating.
6 | P a g e
FAN INSTALLATION
Fig. 6.6
Fig. 7
I N D U S T R I
V e r s i o n 1 . 0
0 4 / 2 0 2 1
Publicité
Table des Matières
