AENO SV1 Mode D'emploi page 8

NOTE: to change °C to °F, press and hold the setting button (6) for 2 seconds.
The device will start working. When the programmed temperature is
reached, the countdown timer will start. The time and temperature readings
on the display (10) will be displayed alternately.
NOTE: the cooking time depends on the thickness of the food, for deep-
frozen foods it is doubled.
After the set time has elapsed, the device will beep. Turn off the device,
unplug it from the mains. Wait until the device has cooled completely and
wipe it with a soft cloth.
Detailed recommendations on time settings and product care are contained
in the full version of the manual, available at aeno.com/documents.
WARNING! If you try to start the unit without water, the display will show
error E03 and the buzzer will sound. The device will not turn on.
Using automatic cooking modes
Automatic programs are available for cooking with different products. Each
program is an optimal combination of temperature and cooking time
depending on the selected dish. Select the automatic program as follows:
 Press the automatic cooking program selection button (7) for 3 seconds.
The preset time and temperature values will appear at the top of the
display, and the program number will appear at the bottom of the display.
 Press the automatic cooking program selection button (7) repeatedly to
set the desired mode: 1 (60 °C/100 minutes), 2 (65 °C/90 minutes), 3
(55 °C/30 minutes) or 4 (85 °C/40 minutes).
 Press the power button (5) to start the selected program.
Troubleshooting
 Indicators on the control panel do not light up after the device is turned on.
Possible cause: no power. Solution: check if the device is correctly
connected to the mains.
aeno.com/documents 8