Packing List; Assembly Instruction - NEO TOOLS 90-099 Traduction De La Notice D'origine

PACKING LIST

•
Heater with wired control panel
•
Instruction manual
•
Accessories pack 1 set:
− 4x plastic rail
− 4x metal screw

ASSEMBLY INSTRUCTION

Unpack your package and find the heater together with the wall mounting accessories pack.
1. Mark the positions of the four holes to be drilled on the wall, and Drill the holes with the drill bit (picture 1). Make sure the distance between
each holes is same as the round holes on the brackets at back of the heater.
2. Insert the plastic rails fitting into the holes (picture 2).
3. Insert the metal screws into the plastic rails (picture 3).
4. Lift the heater and aim the four round holes on the brackets at back of the heater to the 4 screws on the wall (picture 4), and slide the screw
from Position A to Position B by moving the heater slightly (picture 5).
5. Make sure the distance between the bottom of the heater and the floor is no less than 20cm when the heater is installed